LinuxCNC on Linux Mint Debian Edition 6

So most probably it works!
Thank you.

Installed, confirmed, tested, confirmed again, surprised by boot time!
-QtPlasmaC works out of the box
-QtDragon works out of the box
--
Going to attach a Mesa 7i92 (without "T") to it and leave it running for a day or two.

Aha. I came to the Install forum specifically to see if there was a post about LMDE. When I read that their new version is now based on Bookworm, I instantly thought of LinuxCNC. My favorite distro now supports my favorite machine control software with minimal effort. What could be better? image missing /media/kunena/emoticons/cool.png

Thanks for testing this, and posting.

I don’t know why it becomes stuck after installing lmde6 and rt kernel.
It takes more than ten seconds from entering the password to entering the desktop
Opening lcnc is also very slow

What are the configurations of your computers?

Was that question addressed at me or someone else?
If me, here is some of them
-Dell something 980, installed it yesterday, worked all day with a base period of 50000 while doing other stuff on it
-Lenovo M93, works fine
-HP Z220, tested for two days, works fine
---
Have to try on:
HP 8300 USDT
HP Z420
Acer Switch 5 tablet
Lenovo IdeaPad Y700 with Nvidia graphic
and maybe on Lenovo ThinkBook G3 and some others,
Not sure when i will have the chance, though and i have other PC's with Ryzen 3600 and 3700X and AMD and Nvidia graphics.
-
On a personal note, i still do not like some of the Cinnamon's stuff, but i managed to get the temps and loads to show on the panel, so i might just stick with it.
Also, for production machines, i will continue to switch to Debian 12 BookWorm, those use Inkscape and LinuxCNC so all is good there.