Another plasma component...

rodw wrote: Anyway, the good news is once I had pins that actually got the adaptive feed working, I sorted out some code snippets and cutting rules for holes for Sheetcam and it all works nicely.

Rod,

Do you mind sharing your sheetcam post for Plasmac that has the new disable function.

thefabricator03 wrote:

rodw wrote: Anyway, the good news is once I had pins that actually got the adaptive feed working, I sorted out some code snippets and cutting rules for holes for Sheetcam and it all works nicely.

Rod,

Do you mind sharing your sheetcam post for Plasmac that has the new disable function.

Yes, I will when I'm back at work. I did not change much today, the magic is in the cutting rules., not the post processor.

I think the configurator is fixed now...

Cheers, Phill.

phillc54 wrote: I think the configurator is fixed now...

Cheers, Phill.

I just love being the crash dummy. Its a small price to pay for all of your hard work. Just unexpected changes can take some time to understand.

rodw wrote: I just love being the crash dummy. Its a small price to pay for all of your hard work. Just unexpected changes can take some time to understand.

HaHa, sometimes they take me a while to understand as well

Cheers, Phill.

I have pushed a couple of enhancements to the configurator:
You can select from a Run tab or a Run panel
The original plasmac.hal is now split into plasmac.hal and plasmac_connection.hal so there is just a link to plasmac.hal rather than a file in your config directory.
It is also possible ti use configurator to overwite an existing config if you need to make any changes. (as always, backup first...)

Cheers, Phill