- Posts: 149
- Thank you received: 10
plasmac message error
2 years 11 months ago #285769
by beauxnez
Replied by beauxnez on topic plasmac message error
I don't have "feed override" I'm in stepconf
for the rest I will make a video tomorrow
for the rest I will make a video tomorrow
Please Log in or Create an account to join the conversation.
- tommylight
-
- Offline
- Moderator
-
2 years 11 months ago - 2 years 11 months ago #285860
by phillc54
Replied by phillc54 on topic plasmac message error
What is the state of the enabled switch and LED on the THC frame on the MAIN tab?
Do the up/down LEDs on the THC frame on the MAIN tab change state while cutting.
Can you post the file made from the BACKUP CONFIG button on the SETTINGS tab.
Do the up/down LEDs on the THC frame on the MAIN tab change state while cutting.
Can you post the file made from the BACKUP CONFIG button on the SETTINGS tab.
Last edit: 2 years 11 months ago by phillc54.
Please Log in or Create an account to join the conversation.
Moderators: snowgoer540
Time to create page: 0.083 seconds