LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

Since you said the link was wrong, feel free to post the correct one and do a bit of promotion for your Carrot Board

Dear meister:

item.taobao.com/item.htm?abbucket=19&id=...%7D&xxc=taobaoSearch

This is the link.

1.I am not sure if it is appropriate to post my product link here; if not, I will remove it.
2.I’m not a merchant; I’m just a DIY enthusiast. In my spare time, I make small items and sell them in my little Taobao shop. When a customer from China makes a purchase, I get a notification via the Qianniu app; the order includes a Chinese shipping address, and after paying about $1 for shipping, the buyer receives the item in a few days. However, I have absolutely no idea how to handle orders with foreign addresses. I’ve had English-speaking customers place orders before, but the delivery addresses were still within China, so I assume they were likely foreigners living there.
3.I would be very happy if someone could check out my little shop.


Tim
 

Hi Tim if you can post the Gerbers or Kicad that would be useful since Riocore is a open source project.

Cheers
Kam

Hi kzali:

Of course，I post files on Github：https://github.com/TimBBB/DirtyBee-Carrot-BOB

However, I want to remind you that if you plan to make the PCB yourself, manual soldering will be a bit difficult.


Tim
 

kzali wrote:

Hi Tim if you can post the Gerbers or Kicad that would be useful since Riocore is a open source project.

Cheers
Kam
 

The software/Gateware is open source; as for the hardware, it’s up to each individual. It can certainly be closed source and used commercially.

Thanks Tim

I already have a Tangobob. I just comented on this forum for others. Your board is very well designed.

warm regards
Kzali