Brother TC-211

setp hm2_5i25.0.encoder.0N.scale something

I will try tomorrow and get back to you

OK back to errors in LinuxCNC again. When i start up I get

joint 1 on limit switch error. Any ideas ????

Thanks again to everyone here.

I also included the hal file.

mblaszkiewicz wrote: joint 1 on limit switch error. Any ideas ?

Is joint 1 on the limit switch?

If not then what is the value of axis.1.pos-lim-sw-in and axis.1.neg-lim-sw-in ? If either of those is true then that explains it, and you will need to figure out why. It is possible that you need to invert the logic of the limit switch inputs.

If the HAL pins are showing "FALSE" then it may be a transient noise issue.

Yeah. I had the limit switches for the y axis backwards. All set. No run away on x anymore. I will take it. Tomorrow I bring home the indicators home with some gauge blocks and get tuning. Thanks for the info Andy.

Ok can realy use some help. My boss just told me if al is ready the 1st job for machine will be in tuesday. So I have a copy of a mach3 tool changer sub. I was wondering if anyone here can translate it to linux for me. It is for the exact machine I have. Also any pin out call outs would be great in a descriptive file.

Also the sub will open in word pad. And is in romanian