7i76e

Have you changed the drive switches !!!!



This is  a config for a lathe just for test it is setup for ip 10.10.10.10
and only for the X axis

 

So I was reading the manual more and I saw that there the 24v or 5v on the drivers as a switch. I switched it and now the X is jittering! It’s not moving properly but it’s jittering! That’s an improvement lol. I’m going to go back and retry all the suggestions for stuff

Aldenflorio wrote:

So I was reading the manual more and I saw that there the 24v or 5v on the drivers as a switch. I switched it and now the X is jittering! It’s not moving properly but it’s jittering! That’s an improvement lol. I’m going to go back and retry all the suggestions for stuff

???? please explain

I have put a link to a config above .

If you don't answer question I can't help

Okay, so nothing changed but the only difference I made. Was the switch on the driver. I’m sorry. I’m trying. I’m doing this on my mobile so I have to hook my computer up to the internet Ethernet to try out your config

Aldenflorio wrote:

Okay, so nothing changed but the only difference I made. Was the switch on the driver. I’m sorry. I’m trying. I’m doing this on my mobile so I have to hook my computer up to the internet Ethernet to try out your config

What switch on the drive !!!!!!!!!

Please read your posts and see if they make sense as to what you are saying.

Did you set the switches on the drive that I linked to.

If you want to try the config copy it to a usb stick.

If you don't answer questions then I give up.

  I changed this switch. From 24v to 5v. This caused the motors to be able to jog. Why are you getting frustrated with me? I am trying. I’ve thanked you so many times for your time. I don’t know how to respond better. I’m trying to get your configuration working for me but it won’t let me toggle the e-stop. I’m TRYING.

im looking for what you said you linked to me and I did everything you suggested. I don’t know what you mean as linked to me