Advanced Search

Yes, it is a CoreXY machine.

im gonna ttry and use them on my lathe retrofit. To see more info look here and feel free to ask some questions!

forum.linuxcnc.org/38-general-linuxcnc-q...ofitt-feeler-ftc-280

Hallo,
vielen Dank für die Antwort.
Hier die beiden Ordner
.
Hello,
Thank you for your reply.
Here are the two folders

No, just reverse to get pulldowns vs pullups.
You can cut pin 10 but it does nothing but waste a few mW.

Yes I know. I dug up another SSD for my GIGABYTE mini pc so I’m going to do a completely fresh install without compromising my original HD.

Seems like you are trying to set the feed the twice (in gcode and in the material)
I really think you should update QTplasmac.

base pin1 is 5v and base pin10 is gnd
if connect resistor in reverse 5v will connected to port pins through last resistor.
Is it better to cut pin10 of resistor network ?

my1987toyota wrote:

rodw live view. Hopefully Alfred turns out to be a whole lot of not much.
Live View

New stream. YouTube must kill it after 12 hours,,,
www.youtube.com/live/3VYA-qREyUk?si=4PkCLAfy9UbnOy9L

You can remove the resistor networks and install them in backwards
to have pulldowns rather than pullups. I would not simply remove them.

If you do this you should also disable pre-config pullups (W3 down)

Note that you should not do this for Mesa daughtercards that are active low

Is that a CoreXY machine?
If not, remove that line in the ini file and use the line above it.

See if this helps
162.243.45.186/plasmac/36568-post-proces...mac?start=110#212283
Ok just checked and not much there, so
How are you loading the file and from what?
If from network or USB, try copying to HDD and load from there.

7i80hd pullups are removable can remove them to do outputs active high ?
What about internal pullups must disable them also ?

 And when I do get it to load I allways get this notification. Everything still sends to cut ok but maybe it’s time for me to face my fears and just update. 

What is causing this error when I load my Gcode file. It only seams happen when I load a file with a large amount of parts. Some times I can close the notification and reload but today I couldn’t and even closing linuxcnc did not remove it. I had to restart the computer to remove it but it when I loaded the Gcode it showed up agian. The sheet only has 32 parts in it so not overly large. I’m running a plasmaC version at least a few years old as it just works for me and I could not afford the risk of trying yo update and break something.  Thank you, I’m hope it’s just a setting somewhere where I can increase the timeout duration. 

Oh. Forgot to mention. I got a 12mm ballscrew for the cross slide. Hoping it is small enough to make it work.