Mill atc configuration

When connect;
net orient-command => orient.command   
net orient-command => orient-pid.command
Get error orient.command is linked to o_angle  how to solve this?
On the screenshot value from orient-pid.feedback and orient.position is when turn the spindle with hand
 

 

You have two options:

1.option: change your signal definition to this:

net o_angle orient.command sum2.0.in0 sum2.1.in0 orient-pid.command

2.option: reuse the already defined signal and just this line:

net o_angle orient-pid.command

Now linuxcnc start without error.
But after M19.. spindle dont turn and any relay cw/ccw on.
And orient-pid.output still zero
screenshots after M19
 
 

 

Looks like your orient-pid is not doing anything. Can you post your ini file so we can see what you have set these values to:

setp orient-pid.Pgain [TUNE]P
setp orient-pid.Igain [TUNE]I
setp orient-pid.Dgain [TUNE]D
setp orient-pid.bias [TUNE]BIAS
setp orient-pid.FF0 [TUNE]FF0
setp orient-pid.FF1 [TUNE]FF1
setp orient-pid.FF2 [TUNE]FF2
setp orient-pid.deadband [TUNE]DEADBAND
setp orient-pid.maxoutput [TUNE]MAX_OUTPUT

 

Try to change all settings from ini P, I, D etc.
But see only change in orient-pid.output if change Bias, now is set to 80. I can put more but limit is MAX_OUTPUT set to 80 for now.  
But not relays cw/ccw on, or turn spindle.
M19.. finish with TIMED OUT.