ubuntu 14.04.1 linuxcnc help

Jason
Tim wrote

reason I want you to know how to use VM is to test the install process on different OS's

I meant you Jason no one else

Just to test the install process

I do not want to include a VM with install

Tim

grrrr i realized that....

Jason

I sent you a reply to the email you sent me did you get it?

Jason
if you downloaded ISO earlier today or last night. I tried it on Ubuntu and found a mistake. I have to corrected it you can download again later. This will not work with Debian

Tim

Jason
Iso is available for download again it works on Mint xfce, Xubuntu loading up Ubuntu desktop in VM now will give it a go I don't see a problem though.
Note: when you try it, you will see some errors when debs are installing don't worry after first attempt of load on debs the next line in code corrects the issue and downloads the needed packages, then installs all failed debs during first time around. Both distro's Ubuntu and Mint and the flavors will be different but same end results with Linuxcnc installed with kernels and ready to run after reboot.

Tim :laugh:
PS In email I told you to use
su -
With Ubuntu you have to use
sudo su -

Tim
Been a little busy at work. Sorry.
I got this error when installing virtualbox. i have to go pick up my kid and start making dinner. Ill look into what the problem was when i get home, or if youve encountered this what was the solution.
Thanks
Jason
DKMS: install completed.
Setting up virtualbox (4.3.34-dfsg-1+deb8u1ubuntu1.14.04.1) ...
* Stopping VirtualBox kernel modules [ OK ]
* Starting VirtualBox kernel modules [ OK ]
Processing triggers for ureadahead (0.100.0-16) ...
Setting up virtualbox-qt (4.3.34-dfsg-1+deb8u1ubuntu1.14.04.1) ...
Processing triggers for python-support (1.0.15) ...
Processing triggers for libc-bin (2.19-0ubuntu6.6) ...
Errors were encountered while processing:
linuxcnc
E: Sub-process /usr/bin/dpkg returned an error code (1)