ubuntu 14.04.1 linuxcnc help

Note within a VM when you start lcnc you will get realtime delay faults. It should still run if it fails close lcnc then retry. That is because latency is so high in VM and there is nothing you can do about it. If a install will not run for you in VM let me know and I will try on my desktop sometimes it makes a difference in realtime OS.

Jason I am not going to check
Edubuntu
Ubuntu Kylin
Mythbuntu
Ubuntu Studio
Ubuntu MATE no 14.04 release

Virtual box is moving much slower than i would like. I have extra hard drives, it might be easier for me to just use a different hdd. i'll print out a disc with as many os's as i can fit then i can just do a disk install on it. I should be able to fit 3 maybe four a disc.

Jason
64 bit install from ISO worked with all that I checked which included Linux Mint 17.1 and 17.2 and 17.3
What I checked
Mint
Cinnamon (64-bit)
KDE (64-bit)
MATE (64-bit)
Xfce (64-bit)

Ubuntu 14.04.3
Ubuntu.desktop (64-bit)
Ubuntu GNOME (64-bit)
Kubuntu (64-bit)
Lubuntu (64-bit)
Xubuntu (64-bit)

If you would like some help checking 32 bit installs let me know what you haven't checked and I will start on some of whats left.

Tim

Tim
I haven't had much computer time in the last few days. I'm hoping to have time tomorrow afternoon. It's always a little hectic around holidays. I apologize for holding things up on my end. I got as far as burning a disk with mint kde, mate, and cinnamon. I'm hoping I can test these three after work.

Jason
I have made a change in the ISO you should re-download ISO again. The change that I made allows for just a sim install if user would like. I have also finished checking all the 32 bit installs. The ISO will work on Ubuntu 14.04.1 or 14.04.2 or 14,04.3 any flavor and Linux Mint 17.1 or 17.2 or 17.3 any flavor. 32-bit or 64-bit Ubuntu and Mint. On a updated OS the install takes about 5 min.
What I checked
Mint
Cinnamon (32-bit) & (64-bit)
KDE (32-bit) & (64-bit)
MATE (32-bit) & (64-bit)
Xfce (32-bit) & (64-bit)

Ubuntu 14.04.3
Ubuntu.desktop (32-bit) & (64-bit)
Ubuntu GNOME (32-bit) & (64-bit)
Kubuntu (32-bit) & (64-bit)
Lubuntu (32-bit) & (64-bit)
Xubuntu (32-bit) & (64-bit)

It is very easy to use LinuxCnc with both Rtai and Rt kernels if installed and switch is done correctly. ISO can be used multiple times without harm just un-install LinuxCnc before using again. I now have to work on the documentation that will be included.

Tim