Mill atc configuration

Must unlink    #net spindle-orient-output    orient-pid.output  =>  mux2.0.in1   
After link          net orient-pid-output orient-pid.output => wcomp.0.in
With M19.. start on relays cw/cww   dependend of orient-pid.error positive/negative  
How to connect  #net spindle-orient-output    orient-pid.output  =>  mux2.0.in1  and  net orient-pid-output orient-pid.output => wcomp.0.in without error?
 

Ah yes. Since you have already connected 'orient-pid.output' to the signal 'spindle-orient-output' with this line:

net spindle-orient-output orient-pid.output => mux2.0.in1

you need to remove the 'orient-pid.output' pin name from the line that reuses the signal name
So change this:

#net orient-pid-output orient-pid.output => wcomp.0.in

To this:

net orient-pid-output => wcomp.0.in

After change this.
Relays stop working.

Maybe add all the pins of 'wcomp.0.' to the halshow so you can actually see what is going on.

If you attach your current hal file I can have a look at what you did.

Screens 2,3 with net orient-pid-output orient-pid.output => wcopm.0.in  and  #net  spindle-orient-output orient-pid.output => mux2.0.in
Screens 4,5 with net orient-pid-output => wcopm.0.in                                and    net  spindle-orient-output orient-pid.output => mux2.0.in

Could you add the wcomp pins to the halshow watchlist you had in this post?
forum.linuxcnc.org/10-advanced-configura...tion?start=50#278523
Otherwise we are just going around in circles.