New Project with Mesa 7I96 and THCAD-05

I don't know enough about these ohmic components, you may need to connect the is-probing pin, something like:


Then if you press the Ohmic Test button and your switch you may see some action. Put a watch on ohmicsense.ohmic-on

 

Do you have a recommended location for that line, Along with the others in the custom Hal??

Sorry, yeah with those others in custom.hal

will do thanks report in the morning

Ok now I wanting to know about this that you said
 the plasmac.ohmic-probe pin is a generic probe pinout, it can be used by relay (which is what I use)
Would you share the circuit????

this is what I am using on my other table, very simple and works great, water shorts it out sometime, I just dry it and go on.
 
 
 

I have some preliminary docs that I started, I'll put something together tomorrow.