Another plasma component...

Ok, I'm an old Windoze fossil. Now days with Linux you want to use ip command.

John

phillc54 wrote: Only a single NIC on this machine.
I can ping local machines by address or name.
I can ping external addresses but not names.
Time for a coffee.

Cheers, Phill.

Should just work hey!
A lot of sites don't respond to pings these days with the advent of AWS and other cloud services.
Try connecting to a site in your browser.
139.130.4.5 is an obscure Telstra server I test pings against. if it responds your browser should work.

You know the mesa card needs to be on its own NIC?

This machine is actually an old wheezy install with a parallel port so it is running RTAI and it only has a wifi.
I finally managed to get it going, it was a corrupt resolv.conf file, probably something I did earlier, this sort of crap happens often when your are in your sixties...
The good news is that even with my shonky probe setup I get exactly the same issues John was having here so I am confident that I can get this working...

Cheers, Phill.

phillc54 wrote: This sort of crap happens often when your are in your sixties...
Cheers, Phill.

Please do not say that. There are others in that age group too!

John,
I think I have it working now. I am using a go pin .002" small and a nogo pin 0.003" large and the heights for both ohmic and float are consistently within them. I also have the debounce set to 1.

[strike]New plasmac.comp is attached.[/strike]

Cheers, Phill.

EDIT: attachment removed, there is an error in this file that can inadvertently turn the torch on while probing...

I believe most if not all the active participants in this area are there or close to it.

Phill, thanks for all the hard work on this.

John