islander261 wrote: Phill
I have no doubt that the torch enable button color works correctly on you installs, mine did too until the latest. This must be something buried deep because my .ini only differs from the imperial sim at the points required for my hardware.
John
It just ocurred to me that I think John was a bit slower updating so we most likely broke on the same upgrade. I wonder if its becasue we've both dabbled in Glade to make new gmoccappy screens in the past?
Also, can you guys outline how you use the reverse run feature? I've never been able to make it move anywhere.
[
quote]
Those are nice looking parts. Are you using a wire cup brush to clean them up? With no water table you should have the dross flick off with a fingernail if there is any on those long straight sides. Be careful about always using the correct PPE when doing secondary operations on parts, I have had bits of dross end up in all sorts of places I don't want it even with a full face shield and head gear. As I have said before get your self some sort of mass finishing system before the pile of part become overwhelming.
[/quote]
John thanks. I just ran a flap disk over them. There were some burrs where I drilled holes that needed to be cleaned up as well. I'll give a wire brush a go.
I did a fairly busy nest in sheetcam today to clean up an offcut
I'm not sure what happened here.
This was near the beginning of the cut and the edge warped up about 40mm while cutting. I wondered if the air pressure was too low or something. I'll remember to purge the air line with the torch pulse function next time. Managed to work out how to nest parts in sheetcam inside the flange cutout. So much to learn.
