Is there any way to add another tab that has parameters I can set that my gcodes can pull from. Does not need to be fancy just a list of say #0-30. I cut a ton of square sheets out of larger sheets. The size I cut changes depending on what the customer wants. I was planning on writing a program that has its x & y as numbered parameters that auto compute new locations as it runs. So I can enter say 6" long (in Y) and 1.5" wide (in the X) with .25 between and I want 30 of them. It would then start and zero the program where my torch is currently, do a square and move to the next position. I have done macro programming like this before but it was on a fanuc control and I could access the variable page.I was planning on moding the parameters at the beginning of the gcode but a tab would be much nicer to use.
JTK, if you read up on the macros in Gmocappy docs, you may be able to achieve this using the macro buttons. I think only 10 macros display but it is possible to enter variables.
I have pushed an update that changes the THC active LED to a three color LED.
Green indicates that THC is enabled but not active.
Yellow indicates that THC is enabled and active.
Grey indicates THC is disabled.
